Advertisement
Version 1.1
Operation
1. Allow the unit to charge from the solar panel for at least 3 days with the switch in the 'Off' position prior
to initial use. This will ensure optimum performance and maximum illumination.
2. Located on the side of the lamp head there is a switch with two positions. See Fig 3.
a.
'On' – When the switch is in the 'On' position the light will turn on automatically.
b. 'Off' - When the switch is in the 'Off' position the light will remain off and will not detect any
movement.
3. The maximum range of sensor is over 16 Ft as seen in Fig 4 and 5.
4. The WelBilt 36 LED Solar Security Light will stay illuminated for 30 seconds and switch off if no further
motion has been detected.
Note: Light will function when the photo-sensor senses minimal light.
Troubleshooting
If the WelBilt 36 LED Solar Security Light does not illuminate when movement in front of the sensor is obvious
please observe the following:
Ensure the solar panel is in a location where it will receive maximum sunlight during daytime hours.
Ensure the lamp head is away from other light sources. Other light sources at night will prevent the unit
from turning on.
Clean solar cells with a damp towel, Do not apply excessive pressure and avoid the use of any solvents or
cleaning agents on the solar cells.
Ensure switch is set to 'On'.
Check batteries are installed correctly.
Allow the solar panel to charge the batteries in direct sunlight for 3 days with the lamp in the OFF
position.
Replace Batteries.
Note: Rechargeable batteries may last up to 800 charges. For best performance replace batteries every 12
months
3
Advertisement
