Advertisement
Version 1.1
Assembly and Installation
Solar Panel Wall or Deck Mounted Installation
1. Choose an area that receives the maximum amount of sunlight possible.
2. Use the mounting holes located on the base of the solar panel to mark the mounting surface for
installation. See Fig 1.
3. Set the bracket on the surface you have chosen and secure it in place with the 3 smaller screws and
anchors provided.
4. Adjust the angle of the Solar Panel to ensure it receives optimum sunlight.
Note: The Solar Panel is equipped with a 16 ft wire. The maximum distance between the lamp head and
solar panel can be 16 ft.
Lamp Head Installation
1. Use the mounting holes located to the rear of the lamp to mark the mounting surface for installation. See
Fig 2.
2. Secure the lamp to the wall with the larger screws and anchors provided.
3. Carefully route the wire from the solar panel to the lamp and plug it into the power socket.
4. Adjust the motion sensor to your desired position.
Note: Lamp head unit should be mounted 6.5 – 9.8ft from the ground to ensure motion detection is
optimised.
2
Advertisement
