TZIDC-200 DIGITAL POSITIONER | OI/TZIDC-200-EN REV. D
3 Design and function
Schematic diagram
1 Setpoint signal 4 to 20 mA
2 Binary input
3 Binary output
4 Supply air: 1.4 to 6 bar (20 to 90 psi)
5 Exhaust
6 I/P module with 3/3-way valve
Figure 4: Schematic diagram of the positioner
Note
With optional upgrades, either the 'Mechanical digital feedback with proximity switches'
microswitches'
l
can be used. In both cases though, the mechanical position indication
Principle of operation
The TZIDC-200 is an electronically configurable positioner with communication capabilities designed for mounting on pneumatic
linear or rotary actuators.
Fully automatic determination of the control parameters and adaptation to the positioner allow for considerable time savings as well
as optimum control behavior.
Basic device
Optional upgrades
7 Position sensor
8 Plug-in module for analog feedback (4 to 20 mA)
9 Plug-in module for digital feedback
j Mechanical position indication
k Mechanical digital feedback with proximity switches
l Mechanical digital feedback with 24 V microswitches
k
or 'Mechanical digital feedback with 24 V
j
must be installed.
25