Redundant Overload Protection; Tambour Doors; Handle Assembly; Access Panel - Black Box TAB16C-LS Manual

2.2.5 Redundant Overload Protection

• Overload Protection monitors each device for a current overload condition that occurs when the overload current limit is
reached.
• If the overload occurs when the initial charging is turned on, the Overload Protection shuts down the overloaded iPad/device
and will attempt to reset the charging every 30 seconds after all iPad/devices have begun charging.
• If an overload occurs during charging, charging is turned off to all iPad/devices and the charging sequence is restarted to locate
the overloaded iPad/device as described in the previous paragraph.
• If the overload protection fails to remove the faulted current overload, the system microprocessor will reset the power charging
system in an attempt to remove the fault.
• When connecting a laptop to the USB 2.0 port located in the side panel, the TAB16CS-LS or TAB32CS-LS will automatically
switch from charging mode to sync mode. When the syncing mode is started, each device is synced sequentially in order to
avoid USB bus overload.
• The TAB16CS-LS or TAB32CS-LS is switched back to charge mode by unplugging the USB cable from the port on the side
panel.
• If the USB cable is not unplugged from the port, the TAB16CS-LS or TAB32CS-LS switches back to charging mode four hours
after the data sync mode is activated. To restart sync mode, the syncing computer must be disconnected and reconnected to
the TAB16CS-LS or TAB32CS-LS.
• iPads sync with iTunes—see iPad manual for instructions to configure iPads.
• The TAB16C-LS and TAB32C-LS do not have syncing capabilities, but these can be added at a later time if needed.
• Devices connect to the TAB16CS-LS and the TAB32CS-LS with the USB cables supplied with the cart.
• Devices connect to the TAB16CS-LSL and the TAB32CS-LSL with the Apple
cart.
• The carts operate from one power cord.
2.2.6 Tambour Door
• The front of the cart is secured by a tambour door.
• Tambour door is constructed of 1.18" (30-mm) wide and 0.49" (12.5-mm) thick translucent blue PVC slats.
• The door is secured by 16-gauge black steel handles and a reinforced lock hasp. Padlock is optional.
• Retractable design requires smaller footprint to open and provides easier access to stored tablets than hinged doors.
• Translucent door allows for visual inventory of stored items, as well as charging status.

2.2.7 Handle Assembly

• Handle on side of cart frees the top of the cart for an unobstructed work area.
• Two (2) steel cord wraps (the lower portion of the handle assembly and the handle are used as cord wraps).
• Handle can be mounted on either side panel. A second handle option is available for field installation.
2.2.8 IT Access Panel
• Fully removable IT access panel is located on rear of cart.
• Secured via 3-point key lock.
• Provides protection to electrical components.
Chapter 2: Overview
USB-to lightning connector cables supplied with the
®
Page 9