Panasonic DBS 40 Installation Manual page 72

Section 300~installation
Technical Manuals Online! - http://www.tech-man.com
Installing Tl in a Double Cabinet with the Tl in the Slave
1.
Install the Sync Unit in the master cabinet as described in Steps 1 and 2
under "Installation for a Single Tl."
2. Install a Tl MDF card in the slave cabinet. (See Step 3 on page 4-23.)
3. Set Switch 1 on the Tl card. (See Step 4 on page 4-24.)
4. Install a Tl card in the "EQTRK" slot of the slave cabinet.
5. Connect the Sync Cable from CNl on the Sync Unit to CN5 on the Tl
card (Figure 4-l 1).
Note: Part Number VB-43564 is used for the Sync Cable when a Tl is
installed only in the slave cabinet of a' two-cabinet system.
6. At the slave cabinet, connect the cable attached to CN3 on the Tl MDF
card to CN3 on the Tl card (Figure 4-10).
7. Using an RJ48 cable, connect CNl of the Tl MDF card to the CSU. (See
Figure 4-9 on page 4-25 for RJ48 pinouts.)
8. At the slave cabinet, connect the ground cable on the Tl MDF card as
shown in Figure 4-10 on page 4-26.
DBS Manual - Issued 8/l/95
Chapter 4. Trunks and Lines
4-27