Room Tracker; Software Connection - AMC E200T User Manual

ROOM TRACKER

Software Connection

Setup Room Tracker from the disc in the
packing, and enter the main interface as
following.
The software will auto search all devices from
the same network and list all those found in
the camera list. Press the Search button and
the software will search again.
At the main interface, there are four function
modules: Main View, Configure, Upgrade
Firmware, Download.
Main View: It's interface after the software
starts, to search and control the cameras.
Configure: select a camera in the list to
change camera parameters, consisting of
three tabs: Network, System and SD Card.
Network: Set camera IP/URL and port. App
port is for SDK. Stream media is for rtsp and
rtp access to the camera (such as access to
main stream via VLC). Network type is to
identify camera IP type and address.
8
System: set camera name, Change password
(Update PWD), set the main and sub video
streams (RTSP), and reboot the camera
(REBOOT);
SD Card: set the recording parameters, such
as FPS, RES, BPS etc.
Upgrade Firmware: click the button and
select relative file to upgrade;
Download: Search and download recorded
videos.
At the main interface, double click a device
from the camera list and the main view
interface will display the video of the device's
main channel. Please use other stream media
players such as VLC to view the sub channel;
The control interface is under the camera list,
as follows: