ICARO 2000 Alto Owner's Manual page 23

Icaro 2000
03/03/2022
call an authorized dealer, or our factory. We will be pleased to give you any necessary advice.

When replacing spare parts, make sure to note exactly how each component is connected or placed. Never
rush a repair job; by taking your time, you are far less likely to make a mistake in re-assembly.
In brief, your glider will last much longer when treated with care.
General Advice:

The wires must be periodically checked for kinks or broken strands.

Dirty parts must be rinsed with warm water.

A wet glider must be dried before storage.

Don't leave your glider wet for more than one day, because the moisture may give rise to oxidation of the
frame and cause the growth of mould on the sail.

Salt water causes corrosion on all metallic parts. If you land in the sea and survive, you must disassemble
the entire glider and wash all tubes, bolts, wires and the sail thoroughly with fresh water.

If you fly regularly at coastal sites in windy conditions, be aware that evaporated seawater can have the
same effect.

Disassemble your hang glider after a certain number of flights and make a special check for corrosion.
Spare Parts
If you need any spare parts, you may contact your Icaro 2000 dealer or our factory directly. If you should ever
place an order (by phone, fax or e-mail), keep the following information in mind so we may enhance the quality
of our service (fast and accurate) and to avoid ordering the wrong part:

The exact model of the glider.

The glider's serial number.

The name of the part you need or its exact description.

The reference number of the spare part.
The serial number is located on the adhesive label on the rear part of the keel, close to the cable junction.
The name of the parts may be found on the drawings in this manual or in our website.
The reference number of the parts may be found on the labels on each part or on the drawings in this manual or
on the drawings in our website.
Alto – Owner Manual
Page # 23/48
Alto 2022-1-En