Digital Key Pad Operation; Touch Screen Key Pad Operation - Unibloc-Pump LABTOP 200 Series Operation And Service Manual

7.4.1 Digital Key Pad Operation

Standard digital keypad (Figure 7.4.1.1) functions are explained below.
FWD
REV
STOP
UP
DOWN
ENTER

7.4.2 Touch Screen Key Pad Operation

Touch Screen keypad (Figure 7.4.2.1 & Figure 7.4.2.2) is available on select models of LABTOP
information screens, the following base function keypad is shown. Keypad functions are as follows:
Initiates forward run. If the pump is running in reverse when FWD is pressed, it will decelerate to zero
speed, change direction, and accelerate to a preset speed.
Initiates reverse run. If the pump is running in forward when REV is pressed, it will decelerate to zero
speed, change direction, and accelerate to a preset speed.
Decelerates at a preset rate to stop.
In stop mode this causes the running speed to increase in the display only. The new speed may then be
engaged by pressing FWD or REV. In run mode pressing this key increases the speed up to a preset
maximum.
In stop mode this causes the running speed to decrease in the display only. The new speed may then
be engaged by pressing FWD or REV. In run mode pressing this key decreases the speed down to a
preset minimum.
In stop or run modes pressing this key will store the selected frequency as the initial frequency when
the unit is powered up. The frequency is maintained until another frequency is entered.
PROG In run mode, pressing this key will access Level 1 parameters for viewing
only. Holding SHIFT and then pressing PROG will access Level 2 for
viewing only.
Figure 7.4.1.1
®
units. After start up and
Page 33 of 4