Storage - Toro 78562 Manual

2. Remove the damaged or worn grass deflector.
3. Place the spacer and spring onto the grass deflector.
Place the L-end of the spring behind the deck edge.
Note: Make sure that the L-end of the spring is
installed behind the deck edge before installing the bolt
as shown in Figure 48
4. Install the bolt and nut.
5. Place the J-hook end of the spring around the grass
deflector (Figure 48).
Important: The grass deflector must be able to
lower down into position. Lift the deflector up to
test that it lowers into the full down position.
Figure 48
1. Bolt
2. Spacer
3. Locknut
4. Spring
5. Spring (installed)
6. Grass deflector
7. L-end of spring, place
behind deck edge before
installing bolt
8. J-hook end of spring

Storage

1. Clean the bagger attachment. Refer to
Bagger and Bags (page
2. Inspect the bagger attachment for damage. Refer to
Inspecting the Bagger (page
3. Make sure that the bags are empty and thoroughly dry.
4. Check the belt for wear or cracks.
5. Store the machine in a clean, dry place, out of direct
sunlight. If you must store the machine outside, cover
it with a weatherproof cover. This protects the plastic
parts and extends the life of the machine.
27
Cleaning the
24).
26).