Maintenance Procedures; Additional Operating Tips; Maintenance Schedule - JackRabbit CO-JACK 197+ Owner's/Operator's Manual

Table of Contents

Advertisement

14
MAINTENANCE PROCEDURES
1. Move the thro le lever to the low idle posi on.
2. Turn the key to the off posi on.
3. Turn the fuel shut‐off switch to the OFF posi on (to the 
le ).
ADDITIONAL OPERATING TIPS
Cold Weather Star ng Hints:
1. Use proper oil for temperature expected.
2. Use fresh winter grade fuel.  Winter grade fuel has 
higher vola lity to improve star ng.
Angle of Opera on: Do not operate this engine past a 25° 
slope. Engine damage could result from insufficient 
lubrica on.
Engine Speed: Do not tamper with governor se ng to 
increase maximum engine speed. Overspeed is hazardous 
and will void warranty.
High Al tude Opera on: The engine may require a high 
al tude carburator kit to ensure correct engine opera on 
at al tudes above 4000  . (1219 meters). To obtain 
al tude kit informa on or to find a Kohler authorized 
dealer, visit KohlerEngines.com or call 1‐800‐544‐2444 
(U.S. and Canada).
This engine should be operated in its original configura on 
below 4000  . (1219 meters) as damage may occur if high 
al tude carburetor kit is installed and operated below 
4000  . (1219 meters.)
Carburetor Icing:
 
cold weather opera on in normal condi ons can damage 
the engine.
Carburetor icing can take place when certain combina ons 
of temperature and humidity exist. Result of carburetor 
icing is rough running at idle or low speed as well as black 
or white smoke.
To reduce the likely of carburetor icing, air cleaner cover 
can be rotated to draw warmer air from muffler side. For 
cold weather opera on, posi on air cleaner cover with 
sun decal out.
Pump protec on when ambient temperature is 32 
degrees or lower: 
1. Before leaving the last job site of the day, run the 
machine at max idle to draw a vacuum on the system 
sufficient to cause the lubrica on system to func on.
STOPPING
Running engine with cover posi on for 
Then open the sight feed valves far enough to allow a full 
stream of oil to flow into the vacuum pump for 3 to 5 
seconds. This will in most cases, allow enough oil to 
remain in the pump mechanism overnight to prevent the 
freezing of any condensa on and prevent pump damage 
on start‐up.
2. Always be sure to drain the two moisture traps a er 
each job and the end of each working day to prevent the 
condensa on within the traps from freezing.
MAINTENANCE PROCEDURES
WARNING
Accidental starts can cause severe injury or 
death.  Disconnect and ground spark plug 
leads before servicing.  Also disconnent 
nega ve ba ery cable from ba ery.
Normal maintenance, replacement or repair of emission 
control devices and systems may be performed by any 
repair establishment or individual; however, warranty 
repairs must be performed by a Kohler authorized dealer 
found at KohlerEngines.com or 1‐800‐544‐2444 (U.S. and 
Canada).
MAINTENANCE SCHEDULE
Daily
• Drain valves containing oil/water mixture located in 
front of the machine (see figure 11).  Dispose properly in 
accordance with your region's regula ons.  Never open 
the drain valves while the machine is running.
A er first 5 Hours
• Change engine oil.
Weekly
• Check the pump par cle.  The pump par cle filter 
element can be cleaned with dishsoap (Jackrabbit # 57705)
• Check/replace Inline Fuel Filter located above the engine.
Every 50 Hours or Annually
• Service/replace Engine Pre‐cleaner Element. 
(Jackrabbit # 57703).

Advertisement

Table of Contents
loading

Table of Contents