Lucci Fresco 246112 Installation Instructions Manual

Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.

Warranty

•
This luminaire is covered by a 5-year warranty. The warranty is from the date of purchase, not the date of installation.
•
If the luminaire is not assembled and installed by a licensed electrician, the warranty will be void.
•
Please retain the proof of purchase and evidence of installation by a licensed electrician for any warranty enquiries.
•
Warranty will be void if there is any damage due to improper usage or modification to the luminaire.
•
This luminaire is not suitable for use with dimmer switches. Warranty will be void if the luminaire is used on the same
circuit, which has a dimmer switch.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.

Installation Requirements

•
This luminaire must be assembled and installed by a licensed electrician.
•
All wiring and installation of the luminaire must adhere to the latest local and national wiring rules.
E.g. AS/NZS 3000 Electrical Installations.
•
This luminaire is a Class II product, this must be maintained during wiring and installation of the luminaire.
•
Do not exceed the maximum wattage rating.
•
Select a suitable location for installation:
− The mounting point must be able to support 2 times the weight of the luminaire.
− This luminaire is protected against water penetration to IP44 standards, which is water splashing from any
direction. The IP44 rating must be maintained during wiring and installation of the luminaire.
− It is recommended the luminaire is installed on its own switch and not interconnected with other luminaires on
the same switch, as it may cause the luminaire to switch on unintentionally.
− Avoid installing the luminaire in close proximity or on the same circuit to any fluorescent luminaires or ceiling
fans. RFI interference may cause the luminaire to switch on unintentionally.
− See the Sensor Information section in this instruction manual for additional information about the sensor
detection range and sensitivity, to select a suitable installation location
•
The luminaire is not suitable to use with dimmer switches and must not be used with a circuit which has a dimmer.
•
The luminaire must not be used if the protective shield or shade has been cracked or damaged. Replace the
protective shield or shade before using the luminaire.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.
1 | P a g e
WANAKA UP/DOWN WALL LIGHT WITH SENSOR
SKU# 246112
Rated Voltage 220-240V~ 50Hz
v 1 . 0 ( 0 9 / 2 0 2 1 )