Edit From A Camcorder - JVC DR-MV5SE Instructions Manual

EDITING
42
EN

Edit From A Camcorder

You can use a camcorder as the source player and your unit as the
recording deck.
A If the camcorder has no S-VIDEO output connector:
STANDBY/ON
S-VIDEO VIDEO AUDIO
To [VIDEO/AUDIO
((MONO) L/R)] input
Audio/video cable
(not provided)
Player
B If the camcorder has an S-VIDEO output connector (DVD
deck only):
STANDBY/ON
S-VIDEO VIDEO AUDIO
To [S-VIDEO]
To [AUDIO] input
input
S-video cable
(not provided)
Player
VHS DVD
VHS/DVD
VHS DUBBING
Recorder
AUDIO/VIDEO OUT
VHS DVD
VHS/DVD
VHS DUBBING
Recorder
Audio cable
(not provided)
S-VIDEO OUT
AUDIO OUT
Slide the TV/DVD switch to DVD.
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO/VIDEO OUT connectors to the
unit's [VIDEO/AUDIO ((MONO) L/R)] input connectors on the front
panel.
When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and S-VIDEO OUT
REC
PR
connectors to the unit's [AUDIO] and [S-VIDEO] input connectors
DVD
DV IN
on the front panel.
2
Press VHS/DVD on the unit repeatedly to select the recording
deck.
3
Press PR +/– to select "F-1".
Set "F-1 INPUT" to "VIDEO" for the [VIDEO] input connector, or
"S-VIDEO" for the [S-VIDEO] input connector, depending on the
connector being used. (
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press 7 on the unit to start recording. Or while holding 7, press
4 on the remote control. The dubbing starts.
7
Press 8 on the unit, then stop playback on the camcorder.
NOTES:
All necessary cables can be obtained from your dealer.
Refer to the camcorder's instruction manual for operating procedure.
The quality of dubbed picture becomes poorer than that of the
original.
REC
PR
DVD
DV IN
pg. 45)