Table of Contents
Advertisement
too big screw.
1.20 Care must be taken to guard against dust during assembling or dismantling, especially to avoid
dirt from falling in between the screen and the glass lest it should harm the receiving and viewing
effect.
1.21 There is piece of insulator stuck on the rear chassis corresponding to the power supply board.
It is used to isolate the cool part from the hot part. Please take care to keep it intact lest it should
become a potential safety trouble.
1.22 In addition to plasma screen, the glass is a part of high value. It has such functions as
anti-radiation, adjustment of color temperature etc. Please handle it carefully.
Alignment instructions
1. Test equipment
PM5518 (video signal generator)
VG-849 (VGA signal generator)
CA210 (white balancer)
2 Alignment flow-chart
The alignment flow-chart is shown as fig-1
3 Unit adjustments
Connect all the boards according to wiring diagram, connect with power and observe the display.
Method for entering factory menu: press "INPUT", "2", "5", "8" and "0" in turn to enter factory menu;
press "CH+" and "CH-" to select adjustment items and press "VOL+" and "VOL-" to adjust value
items, press "MENU" continuously to exit.
Check DDC, HDCP KEY, FLASH and POWER control IC
Combined test for general assembly
Factory initialization setup
IF channel voltage of TV and AGC voltage adjustment
White balance adjustment
Performance check
Preset ex-factory
Fig-1 adjustment flow-chart
3
Advertisement
Table of Contents
