Switching Off Water Softening - Bosch SGS4HTI33E User Manual

NL Softening System
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
3. Note: Only use dishwasher
softening salt.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
1
Funnel
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
Install and close the reservoir lid.
4.
Depending on the
1
24
a
device version
Switch off water softening
If the refilling salt indicator bothers
you, for example if you use a
combined dishwasher detergent with
a salt component, you can switch off
the indicator.
Remark
To avoid damage to the
appliance, only switch off the
water softening in the following
cases:
sex The water hardness is maximum
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. According to
the manufacturer's instructions,
combined dishwasher detergents
with salt substitutes can only be
used up to a degree of hardness of
21 °dH without adding softening
salt.
sex The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
Press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
a The display shows Hxx. a
The display shows
to give.
Just as often on
3.
the display shows H00.
To save the settings, press . for
4.
about 3 seconds
a The water softener has been
switched on and the refill
softener salt indicator is
deactivated.
Busy-
reflected
press until
to press.