Installation Of Accessories - Zephir ZUW9000 Manual

17. When installing or relocating the air conditioner, be sure to bleed the refrigerant circuit to ensure it is free of air, and
use only the specified refrigerant (R32).The presence of air or other foreign matter in the refrigerant circuit causes
abnormal pressure rise,which may result in equipment damage and even injury.
Installation guide
This air conditioner meets the safety and operation standards promulgated by the Nation.
 You need to invite professional air conditioner service and maintenance personnel to install or remove the air
conditioner. Problems may occur and you may suffer losses if non- professionals install the air conditioner.
 User shall provide the power that meets installation and operation requirements. please refer to nameplate for details
about the voltage for this product. Voltage beyond this scope will affect the normal operation of the air conditioner.
 Separate power point with delay fuse protector or automatic breaker should be used for the air conditioner.
 The air conditioner must be correctly and reliably grounded, or it may cause electric shock or fire.
 Do not switch on the power of the air conditioner before well connecting and carefully checking the tubing and wires.
 The appliance shall not be installed in laundry or bathroom.
 In case necessary, please consult your supply authority for system information.
 The plug shall be accessible after installed the appliance.
 This instruction is subject to change without notice.
Installation of accessories
 Examine carefully the attached packing list and check whether the accessories are complete.
 Users may need to buy at their own expenses the articles not included in the packing list and may be needed in
installing.
Position for Indoor Unit
 Away from the place where there is heat source, steam source,
leakage of flammable gas and smoke.
 No obstacles near the inlet and outlet, and keep good ventilation.
 Good discharge for water.
 At least 1m away from wireless equipment (such as TV, radio etc.).
 Mounted on the wall that can bear the weight of the air conditioner
and won't produce noise while unit working.
 The distance between the indoor unit and the floor should be
greater than 2.3m.
 The plug shall be accessible after installing the appliance.
 Ensure the distance as required in Fig.1.
 The back of the indoor unit should be close to the wall (Fig.1)
 The all figures are only schematic, and they may be slightly different from the actual appliances you selected.