Table of Contents
Advertisement
Figure 2. Standard Hitch and Quick Hitch Configurations
Driveline Attachment
CAUTION
Make sure driveline will not bottom out at the
shortest length and that it has at least 4" overlap at
the longest length.
Attach the cutter to the tractor 3-point hitch (or quick hitch
if available). Do not attach driveline. Raise and lower cutter
to determine maximum and minimum distance between
the tractor PTO shaft and the gearbox input shaft. If the
distance is too large, the driveline will be too short for
proper engagement. If distance is too small, the driveline
may bottom out in operation and damage the cutter or
tractor.
There must be at least 4 inches of engagement at the
cutter's lowest possible point of operation.
If driveline is too short, please call your dealer for a longer
driveline.
The driveline must not bottom out when raised to the
maximum height possible.
If driveline is too long, please follow the instructions for
shortening the driveline.
Installation and Removal of
Driveline (Tractor PTO)
To Install:
Pull locking collar back and at the same time push
driveline onto tractor PTO shaft until locking device
engages.
To Remove:
Hold driveline into position, pull locking collar back, and
slide driveline off tractor PTO shaft.
Figure 3. Lock Collar
OPERATION
13
Advertisement
Table of Contents
