Advanced Bionics ROGER PEN Quick Manual

DEVICE DESCRPITION
Roger Pen is a microphone that picks up the voice of a speaker and sends it wirelessly directly into your
hearing devices. You can place Roger Pen in the middle of a table e.g. in a restaurants, or it can be worn
by a single person i.e. to hear a distant talker. Follow the steps below to pair the Roger Pen.
PAIRING ROGER PEN TO A
PROCESSOR OR HEARING AID
1 Turn on the Roger Pen. Ensure the
appropriate battery to the Roger receiver is
attached to the processor or hearing aid.
2
Hold Roger Pen within 10 cm/4 inches from
the Roger receiver or hearing aid.
3
Press the "Connect" button
of the Roger Pen.
TIP
The front indicator light will turn green for two
seconds to confirm a successful connection.
You can connect an unlimited number of Roger
receivers to your Roger Pen, simply repeat step 2
and 3 for any other Roger receiver.
Pen
Blue Blinking
Solid Green
Red Double
Blinking
Red Triple
Long Blinking
STANDBY MODE
To enter standby mode, press and hold the
1
on/off button to put Roger Pen into Bluetooth
standby mode. This means the Roger Pen
microphone is switched off but incoming
calls can still be received.
In Bluetooth standby mode, the battery of the
2
Roger Pen is drained. It is recommended to
switch off the Roger Pen completely if no
calls are expected to be made.
on the side
Connecting or
pairing mode
Connecting/pairing
successful
Connect timeout,
move device closer
Device not
compatible
ROGER™ PEN
PAIR ROGER PEN WITH YOUR PHONE/
COMPUTER (BLUETOOTH)
1
Turn on the Roger Pen and phone/computer.
Place next to each other.
2
Ensure the phone/computer Bluetooth setting is
enabled.
3
On the phone/computer, choose SEARCH or
SCAN to search for Bluetooth enabled devices or
audio enhancements.
Press the Accept button for 7 seconds until the
4
indicator light blinks blue.
The phone/computer should present a list of
5
Bluetooth devices it has detected. Choose
"Roger Pen" from this list and confirm the
connection is established.
The Roger Pen should now be paired to the
6
phone/computer and the indicator light will stop
blinking.
TIP
The phone/computer may ask to enter a
passcode. If so, enter '0000'. Some
phones/computers may ask which Bluetooth
service you want to enable, select Headset audio
device and microphones in parallel.
Blue Slow
Blinking
Blue Solid
Blue Solid
Blue Fast
Blinking
QUICK GUIDE
Bluetooth Standby
Mode
Incoming Call
Active Call
Network Issue,
please press the
connect button