Gigabyte GA-F2A88XM-DS2 User Manual page 11

D-Sub Port
The D-Sub port supports a 15-pin D-Sub connector. Connect a monitor that supports D-Sub connection
to this port.
DVI-D Port
Connect a monitor that supports DVI-D connection to this port. Please note that the actual resolutions
supported are dependent on the monitor being used and support for 2560x1600 resolution requires both
a monitor and cable that support Dual Link DVI.
Playback of a Blu-ray Disc
In order to get better playback quality, when playing a Blu-ray Disc
AMD A series processors
is enabled. Whether Hardware Acceleration can be enabled for 3D Blu-ray discs is dependent on the
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
Connection/
Speed LED Activity LED
LAN Port
USB 3.0/2.0 Port
The default line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.
The default line out jack. Use this audio jack for a headphone or 2-channel speaker. This jack can be used
The default Mic in jack. Microphones must be connected to this jack.
multi-channel audio feature through the audio driver.
device and then remove it from the motherboard.
When removing the cable, pull it straight out from the connector. Do not rock it side to side to prevent
an electrical short inside the cable connector.
:
™
Connection/Speed LED:
State Description
Orange 1 Gbps data rate
Green 100 Mbps data rate
Off 10 Mbps data rate
- 11 -
, refer to the recommended system
™
Activity LED:
State Description
Blinking Data transmission or receiving is occurring
Off No data transmission or receiving is occurring