Nikon Z9 Settings Manual page 24

Hide thumbs Also See for Z9:

Table of Contents

Picture Quality, Continued

Measuring a New Value for Preset Manual White Balance

■

Use preset manual white balance to measure a custom white balance value for the current light

source and save it for later recall.

Hold the U button and rotate the main command dial to select L.

Hold the U button and rotate the sub-command dial until the des-

tination preset is displayed.

Choose from presets d-1 through d-6.

G G

Release the U button briefly and then press it again to select direct

measurement mode.

The L icon in the shooting display will flash.

G G

A white balance target (r) will be displayed in yellow in the cen-

G G

ter of the frame.

While L flashes in the display, use the multi selector to position the

r over a white or gray area of the subject.

To zoom in on the area around the r for more precise position-

G G

ing, press the X button.

Position the target (r) using the multi selector.

G G

To measure white balance, press the shutter-release button all

G G

the way down or press J.

You can also position the target (r) and measure white balance

G G

by tapping the display.

Press the i button to exit direct measurement mode.

Settings

Table of Contents