Advertisement
Now tap the "Join/Reset" button as shown and the sensor should be added to your Almond. The LED
4
will flash to indicate that the sensor is being added.
Battery
Reattach the rear cover of the sensor and make sure it snaps in place properly.
5
On the Almond 2015 touchscreen, go back to the "Home" screen and tap on "Connected Sensors". Tap on the
6
sensor you just added. Next, tap on "Tampered" to reset the tamper switch. Your sensor should now be fully
operational and ready to be installed at your location of choice.
You can adjust the sensitivity and timer on the motion sensor using a flat screwdriver at the top of the sensor.
7
S T E P 6
Open Almond App and open Devices tab.
1
For each of the Devices, click on the
2
Now change the notification frequency to 'When in Away' from 'Never' next to
3
Notify Me settings.
On the top of the screen, toggle between
4
and
receive notifications (arm security system)
Now you are all set to receive notifications on your phone and monitor your home remotely.
All manuals and user guides at all-guides.com
Zigbee
Hue
Setting-Up Alerts and Arming the system
Sensors
Add Sensors
Add
Remove
Remove all Sensors
Tamper switch
Join/Reset button
Scenes
Rules
to stop notifications (disarm security system)
Adding Sensor...
Please wait
Router
NOTIFY ME
Always
When I'm away
Never
Advertisement
