Table of Contents
Advertisement
Hardware Installation
2-1
Install LGA 775 Supported Intel Processor
This motherboard provides a 775-pin surface mount, LGA775 Land Grid Array socket,
referred to as the LGA775 socket supports Intel Pentium 4 processor in the 775 Pin package
utilizes Flip-Chip Land Grid Array (FC-LGA) package technology.
The CPU that comes with the motherboard should have a cooling FAN attached to prevent
overheating. If this is not the case, then purchase a correct cooling FAN before you turn on
your system.
WARNING!
1.Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it may
cause the processor and motherboard overheat and damage, you may install
an auxiliary cooling FAN, if necessary.
2. Suggest the power of CPU should below 65w.
To install a CPU, first turn off your system and remove its cover. Locate the LGA775 socket
and open it by first pulling the level sideways away from the socket then upward to a
90-degree angle. Insert the CPU with the correct orientation as shown below. The notched
corner should point toward the end of the level. Because the CPU has a corner pin for two of
the four corners, the CPU will only fit in the orientation as shown.
2-2 Install Memory
This motherboard provides two 240-pin DDR2 DUAL INLINE MEMORY MODULES
(DIMM) socket for DDR2 memory expansion available from minimum memory volume of
128MB to maximum memory volume of 8GB DDR2 SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DIMM1) DDR2 533/DDR2 667/DDR2 800
Bank 2, 3 (DIMM2) DDR2 533/DDR2 667/DDR2 800
Total
Recommend DIMM Module Combination
Chapter 2
240-Pin DIMM
Memory (Max.8GB)
Colden Arrow
CPU LGA775 Socket
5
PCS
Total Memory
X1
4GB
X1
4GB
2
8GB
Hide quick links:
Advertisement
Table of Contents
