Table of Contents
Advertisement
Available languages
Available languages
Operating
Predefined programs (P1 to P3)
The heating phases of the predefined programs are shown in the
following tables. A black square represents the heating mode operation
mode, an empty cell represents the setback mode operation mode.
The programs cannot be changed.
Clock
1
2
3
Mon ... Fri
Sat ... Sun
Table 2 Program P1
Clock
1
2
3
Mon ... Fri
Sat ... Sun
Table 3 Program P2
Clock
1
2
3
Mon ... Fri
Sat ... Sun
Table 4 Program P3
Setting the operating modes for the individual program (P4)
The operation mode heating mode or setback mode itself can be
selected for each hour in this program.
▶ Press the
key to activate the standby function.
▶ Hold the
key pressed down until the
the upper part of the display.
▶ Press the
key until the message
part of the display.
▶ Press the
key.
A sequence can be selected for each weekday (1=Mon to 7=Sun). The
day of the week that is being set is indicated by an arrow underneath it.
The setting starts with 1 and is made on an hourly basis.
From 00:00 o'clock, the operation mode (heating or setback mode)
must be selected for each hour for all 24 hours.
▶ Press the
key to select the heating mode operation mode.
The time bar turns black.
▶ Press the
key to select the setback mode operation mode.
The time bar disappears.
▶ Press the
key to confirm the setting for day 1.
The next day is displayed.
▶ Setting further days.
▶ Press the
key to confirm the setting for each day.
Once day 7 is configured, the appliance reverts to the standby
function.
▶ Select and switch on the required function or operating mode.
If no key is pressed for 10 seconds, the appliance reverts to the standby
function.
16
4
5
6
7
8
9
4
5
6
7
8
9
4
5
6
7
8
9
message appears in
appears in the bottom
10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Example
21
18
15
Fig. 4
Setting individual program (P4) (example)
Setback mode from 00:00 to 6:00 o'clock = no bar
Heating mode from 6:00 to 11:00 o'clock = black bar
Setback mode from 11:00 to 16:00 o'clock = no bar
Heating mode from 16:00 to 24:00 o'clock = black bar
5.6
Frost protection mode
The temperature is set permanently to 7 °C in the frost protection
operation mode. The appliance is activated if the room temperature falls
below 7 °C.
We recommend setting this operation mode if the room is not going to be
used for several days.
▶ Press the
key to switch off the standby function.
▶ Press the
key until the
0
p4
3
6
1
7
2
6
3
4 5
9
12
symbol appears.
Heat Radiator 4500 – 6720883002 (2019/10)
0010027140-001
Advertisement
Chapters
Table of Contents
