Safety Devices; Cleaning And Maintenance; Specifications - Linea DOMO DO7348H Instruction Booklet

SAFETY DEVICES

This heater is protected with an overheat protection that switches off the heater automatically in case
·
of overheat, e.g. due to the total or partial obstruction of the grids. The overheating shut-off switches
off the temperature inside when the appliance exceeds the normal running temperature. The heating
element will automatically stop working, the motor will continue to operate, the internal heat shed.
This protective device applies only to the appliance itself and has no influence on room temperature
regulation. In this case, unplug the appliance, wait about 10 minutes for it to cool and remove the
object that is obstructing the grids. Then switch it back on as described above. The appliance should
operate normally. Should the problem persist, please contact the nearest customer service.
The appliance is also equipped with a tip-over safety, which is integrated in the appliance. The
·
appliance will turn off when it tips over.

CLEANING AND MAINTENANCE

· Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down
completely.
· To avoid the risk of electric shock, do not clean the heater with water and do not immerse it. Clean the
housing with a damp cloth.
· If necessary, dust particles accumulated in the air outlet openings may be removed with a vacuum
cleaner. This maintenance should be done regularly to assure the good operation of the appliance.
Dust particles in the appliance may cause over-heating.
· For a thorough cleaning, remove the cover of the air intake with
a horizontal sliding movement. Take out the filter. This filter and
the cover can be cleaned in lukewarm water with a mild detergent.
Make sure the filter and cover are completely dry before putting
them back in the unit. This can be done on both sides of the unit.
Make sure that you correctly replace the parts in the unit before
using the unit again.
· Allow the unit to cool down completely before storing it.
· Store the appliance in a clean and dry place.

SPECIFICATIONS

Model identifier(s):
Item
Heat output
Nominal heat output
Minimum heat output
(indicative)
Maximum continuous
heat output
24
DO7348H
Unit
Symbol Value
kW
Pnom 1.5
kW
Pmin 1.0
kW
Pmax 1.5
Item
Type of heat input, for electric storage
local space heaters only
manual heat charge control,
with integrated thermostat
manual heat charge control
with room and/or outdoor
temperature feedback
electronic heat charge control
with room and/or outdoor
temperature feedback
Unit
N/A
N/A
N/A