Naomi Home Cyra Assembly Instructions Manual page 3

 NEVER use a wall mount bracket from another manufacturer.
 This product is not intended to be a primary heat source. It is for supplemental heat only.
 INDOOR use only! NEVER use this heater outdoors! Doing so may result in electric shock!
 Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside!
 ALWAYS turn this heater off before unplugging it from the outlet.
 ALWAYS disconnect this unit from the power supply before performing any assembly or
cleaning, or before relocating the electric fireplace.
 NEVER leave this heater unattended. ALWAYS unplug this heater when not in use.
 ALWAYS store this heater in a dry location.NEVER use the fireplace if it has become wet.
 NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or
connections. Plugging this heater into a faulty outlet could result in electric arcing within
the outlet that could cause the outlet to overheat or catch fire.
 ALWAYS check your heater cord and plug connections with each use!
i) MAKE SURE the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs
can cause the outlet to overheat.
ii) Heaters draw more current than small appliances. Overheating may occur even if it
has not occurred with the use of other appliances.
iii) During use check frequently to see if the plug outlet or face plate is HOT!
iv) If the outlet or face plate is HOT, discontinue use immediately and have a qualified
electrician inspect and/or replace the faulty outlets.
 The power cord supplied with the heater
has a plug with two flat blades (live and
neutral) and one round pin (ground). If a 3-
slot receptacle is not available, an adapter
MUST be used. The adapter MUST be
properly grounded to the outlet box (see
figure at
INCLUDED.)
 SAVE THESE INSTRUCTIONS!
PREPARATION
This product includes a GLASS panel! Always use extreme caution when handing
glass. Failure to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grounded for wall-hanging or recessing use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever
possible. You will need the following tools (not included): Phillips screwdriver; stud finder; level;
tape measure; electric drill; 1/4" wood drill bit, hammer.
WARNING
right).(Note:Adapter
CAUTION
NOT
.
Page 3 of 17