Philips 5214U Series User Manual page 34

3 - Click Send ID.
4 - If new software is available, download the .zip
file.
5 - After the download, unzip the file and copy the
file autorun.upg onto the USB flash drive. Do not
place this file in a folder.
Update the TV software
1 - Insert the USB flash drive into the TV again. The
update starts automatically.
2 - A software update can take several minutes. Do
not press the  key on the TV or remote control. Do
not remove the USB flash drive.
3 - When the update is done, the TV will return to the
channel you were watching.
If a power cut occurs during the update, never
remove the USB flash drive from the TV. When the
power returns, the update will continue.
To prevent an accidental update of the TV software,
delete the autorun.upg file from the USB flash drive.
Software Version
To view the current TV software version...
1 - Press //, select Settings  and
press OK.
2 - Select Update Software > Current
Firmware and press OK.
3 - The version, release notes and creation date are
shown.
4 - Press  (left) repeatedly if necessary, to close
the menu.
Update from website
You can find the current firmware version of your TV
in the settings menu under "Update Software" >
"Current firmware".
Regularly check www.philips.com/support for new
Firmware updates.
Follow the instructions below to update the firmware
of your TV.
Download the latest software...
1 - Launch the Internet Explorer.
2 - Enter the Philips support site at url
http://www.philips.com/support .
3 - Enter the model number. (You can find your
model number from the label on the rear of the TV. )
4 - When enter your TV's product page, select
Support.
5 - Select "Software updates", and click on
"Download file" to download the software. (The
software is available as a zip file.)
6 - If the software version is higher than the version
installed on your TV, click the software download
link.
7 - Accept the license agreement/Terms and
Conditions, select "I agree", then the zip file will be
downloaded automatically.
8 - Unzip the zip file to any directory using an archive
utility.
9 - Create a folder name "upgrades" in the main
directory of your USB flash drive.
10 - Copy the upg file you have extract earlier into
the upgrades folder, as depicted in the picture
below.
11 - Disconnect your USB flash drive from the
computer.
Update the software...
1 - Connect your USB flash drive (containing the
software update) to the USB connector on the TV.
Wait 30 seconds or until the USB drive is recognized
by the TV.
2 - Your TV will start loading the software
automatically.
3 - When the loading of the software finished, press
"Start" to activate the upgrade of the TV.
34