Table of Contents
Advertisement
* Important: I f a remote control button does not work when pressed, press the
and try the button again.
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as programmed.
Review, Replace or Clear Program
Contents : ( Recording is not in progress )
1
Repeat steps 1 and 2 on page 30.
2
CANCEL : ADD / DLT
SELECT 1 - 8 :
ENTER : SET
END
: PROG
3
To Replace program...
DATE
START
STOP
8 SAT 9:00P 12: 00A 08
TODAY
- - - - - - - - -- - - - - - - -- - - - - - -
SELE CT START DATE
SELECT :
SET
: SET
BACK :
END
: PROG
To Clear program...
P DT START
STOP
1
-- -- : -- -- : --
2
8 10 : 00p 12 : 00a 125
3 10
8 : 00p 9 : 00p 10
4 SU
9 : 00p 10 : 00p
SELECT 1 - 8 :
ENTER : SET
END
: PROG
4
Press PROG twice to exit this mode.
Notes
• 2 minutes before Timer recording is performed,
"PLEASE PREPARE FOR TIMER REC" appears
and/or the PROG TIMER Indicator flashes.
Be sure a cassette with record tab is loaded and the
unit is in Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up
during a normal recording or One Touch Recording
(page 18), the Timer Recording will not be performed.
• If there is a power interruption of more than one
minute, the recording may not be performed or
continued.
• If "INCOMPLETE" appears after all items have been
set, check all entries and make necessary
corrections.
button on the remote
Press
to select
the desired program.
1) Press SET to display.
CH
2) Press
and press SET or
SLP
to set new
program contents.
3) Press PROG.
Press ADD/DLT.
CH SPD
--
--
SP
SP
L
LP
to select
31
Advertisement
Table of Contents
