Setting Up The Tv; Connecting The Tv Signal Source - HP LC3760N User Manual

4
Insert the assembled stand into the opening on the
bottom of the TV.
5
Insert four long screws into the holes on the back
of the TV and tighten using the provided tool.
6
Carefully lift the TV and set it upright.

Setting Up the TV

Set up the TV by connecting cables and connecting the
power cord.

Connecting the TV signal source

w
WARNING: Before connecting the TV to any
other electronic device, unplug the TV and
electronic device AC cords from the AC
input.
The following is an explanation of the types of
connections that are used for a coaxial cable. If your
outdoor antenna uses a 75-ohm coaxial cable with an
F-type connector, plug it into the antenna/cable
terminal at the rear of the TV set.
A 75-ohm system is generally a round cable with
■
an F-type connector that can easily be attached to
a terminal without tools (sold separately).
A 300-ohm system is a flat, twin-lead cable that
■
can be attached to a 75-ohm terminal through a
300/75-ohm adapter (sold separately).
n
An F-type connector should be finger-
tightened only. When connecting the RF
cable to the TV set, do not use tools to
tighten the F-type connector, as it may
cause damage to your TV set.
A
B
A: 75-ohm coaxial cable, round
B: 300-ohm twin-lead cable, flat
C: F-type connector
C
9
Setting Up