Problem / Solutions; Warning - Intec i-starter 6.0 User Manual

English
PROBLEMS / SOLUTIONS
Problem
No response when pressing the
switch button.

WARNING

1. Read the instruction manual carefully before using this unit.
2. Jump for 12V vehicles , it would be hazard if for other jumping.
3. DO NOT use this unit if any cable clamp or cord is damaged.
4. DO NOT use in place of a vehicle battery.
5. Never remain the unit on car battery after cranking the car success.
6. Make sure to check all the battery connections are CLEAN before Jump Starting! Make sure the
battery clamps are well connected! If the battery terminals on the vehicle are dirty or corroded,
the power of the unit will be lessened.
7. Do NOT Jump Start more than 3 times in a row. It could damage the unit by overheating. When
starting up multiple times, each start-up interval is two minutes.
8. Remove the product from the vehicle battery within 30 seconds of Jump Starting. If not, it could
lead to damage.
9. Do NOT connect the two clamps together.
10. Do NOT use by young or infirm persons without supervision.
11. Do NOT use as a toy.
12. Do NOT allow the product to become wet.
13. Do NOT immerse the product in water.
14. Do NOT operate the product in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
15. Do NOT modify or disassemble the Jump Starter. Only a repair technician may repair this unit.
16. Do NOT expose product to extreme heat or fire.
17. Make sure someone should be within range of your voice or close enough to come to your aid
when working with batteries.
18. Remove personal metal items like rings, bracelets, necklaces, etc. When using the products.
19. Do NOT drop unit. If unit receives a sharp blow or is otherwise damaged in any way have it
checked by a qualified battery technician.
14
Cause
Low voltage protection of
device is started.
Solution
Plug the adaptor into the
Quick Charge input port to
activate.