Skip-Line SC-12 Cab Master Quick Start Manual

Installation Overview:

The SC-12 Cab Master is an accessory to the base SC-12 system. It is not required for proper

operation of the control system. An SC-12 Cab Master provides a convenient striping overview

and can take control of either carriage, which allows it to be used as a spare SC-12 Master.

The SC-12 Cab Master is usually located in the front cab, between the driver and passenger. It

can be used for single-operator operations or with a driver and passenger.

Normal SC-12 Masters are designated Left or Right. The SC-12 Cab Master has neither

designation at shipping, but can override either side using the Quick Setup menu.

The optimal viewing angle for the SC-12 Cab Master display is straight-on or from the bottom

up. Skip-Line recommends the SC-12 Cab Master be mounted in a manner that can be "tilted"

so the top of the unit is further away from the operator than the bottom of the unit.

The SC-12 Cab Master has nutserts on either side of the unit (to the left and to the right of the

front panel). These nutserts should be utilized so the SC-12 Cab Master is tiltable, using a

U-shaped bracket.

The nutserts accept a Skip-Line supplied #14-32 Hex Bolt. ¾" length (12mm x 1.75mm x 20mm)

Please mount in a location free from exposure to:

● Water

● Pressure Washing

● Excessive mechanical vibration

● Temperature extremes

● Intermittent, poorly regulated, highly inductive, or noisy power sources

The SC-12 Cab Master gets power and communications from one of the BUS-012 hubs (usually

the front hub, although it does not matter) via a CAT5 cable. Connect the SC-12 Cab Master to

Table of Contents

Do you have a question about the SC-12 Cab Master and is the answer not in the manual?

Page 1 The SC-12 Cab Master has nutserts on either side of the unit (to the left and to the right of the front panel). These nutserts should be utilized so the SC-12 Cab Master is tiltable, using a U-shaped bracket.
Page 2 5 meters (16.4 feet). The Hubs accept only standard RJ45 plugs. Some of the devices have sealed RJ45 jacks, available from Skip-Line, which will accept either standard or strain-relieved IP-67 rated plugs. See Appendix B of the SC-12 Manual for instructions on RJ45 568-B connector wiring.