Copyright; Available Versions And Configurations; Receipt - Ferroli EGEA 200 LT User, Installation, And Maintenance Manual

2.4 Copyright

These operating instructions contain information protected by
copyright. No part of these operating instructions may be pho-
tocopied, duplicated, translated or recorded on storage media
without prior permission from the supplier. Any violations will be
subject to compensation for damage. All rights, including those
resulting from the granting of patents or registration of utility
models, are reserved.

2.5 Available versions and configurations

This appliance incorporates a 1.9 kW heat-pump unit and can
be set up in different configurations, according to possible inte-
gration with additional heating sources (e.g. solar heating) or
depending on boiler capacity.
Version Configuration description
200 LT
Air heat pump for domestic hot water (DHW) pro-
duction
260 LT
200 LT-S
Air heat pump for the production of domestic hot
water (DHW) with solar coil.
260 LT-S
EN
92
EGEA
200 LT - 260 LT - 200 LT-S - 260 LT-S
3. HANDLING AND TRANSPORT
The equipment comes in a cardboard box(*).
It is secured to a pallet by means of three screws.
For unloading operations use a forklift or an adequate pallet
truck.
The packed equipment can be placed horizontally and back
down to facilitate undoing the anchoring screws.
Unpacking must done carefully so as not to damage the equip-
ment casing if using knives or cutters to open the cardboard
packaging.
After removing the packaging, check the integrity of the unit. If
in doubt, do not use the unit; contact authorized technical per-
sonnel.
Before eliminating the packaging, according to the applicable
environmental protection regulations, make sure all the acces-
sories supplied have been removed.
(*) Note: The type of packaging may undergo variations at the
discretion of the manufacturer.
For the entire period the equipment remains idle, awaiting com-
missioning, it is advisable to put it in a place protected from
atmospheric agents

3.1 Receipt

In addition to the units, the packages contain accessories and
technical documentation for use and installation. Check that the
following are present:
• 1x user, installation and maintenance manual;
• 3x fastening brackets plus screws;
• 1x thermal cut-out (only for EKHHE200PCV3 and
EKHHE260PCV3).
For the entire period the equipment remains idle, awaiting com-
missioning, it is advisable to put it in a place protected from
atmospheric agents.
cod. 3541T600 - Rev. 08 - 12/2021