Advertisement
Available languages
Available languages
The code-keypad may only be operated by people who are familiar with the
Only use the code-keypad when you are in view of the gate/door.
Specifica�ons
Input voltage: 12-24 V DC
Idle current: ≤50 mA
Reading distance of EM & HID cards: 5 cm
Reading distance of Mifare & CPU card: 2 cm
Card reader antenna frequency: 125 KHz & 13.56 MHz
Dimensions: 170 x 83 x 26 mm
IP: 68
Working temperature: -20 to +60°C
Working environment humidity: 0-95% (non-condensing)
Ar�cle number: ST161003
Model number: Titan
Package Contents
1 pcs. Code-Keypad Titan
1 pcs. instruc�on manual
1 pcs. drilling template
4 pcs. screw anchors - Φ6 mm × 30 mm
4 pcs. screws - ΦKA4 mm × 25 mm
Moun�ng Instruc�ons
1. Place the drilling template on the desired place on the wall. Drill a Φ14 mm hole for the cable and the
four Φ6 mm holes for the bracket. Place the anchors into the moun�ng holes.
2. Unscrew the an�-dropping screws on the bo�om of the keypad, now remove the backplate from the
keypad. Place the bracket over the holes and use the screws to fix the bracket to the wall.
3. Before placing the keypad onto the bracket, ensure that the cable length is at its required length - the
cable can be shortened if necessary. CAUTION: going forward, the only cables that will be required for
the use with a garage door operator, gate operator, or house door are BLACK, RED, PURPLE, and BLUE
or ORANGE (depending on your system). All other cables can be ignored and should be clipped short or
taped off with electrical tape so as to ensure they do not come into contact with any other cables/sur-
faces.
4. Place the cable through the middle hole of the bracket and place the keypad onto the bracket. Rescrew
the an�-dropping screws to ensure the keypad is securly mounted and lastly replace the screw-cover at
the bo�om.
WARNING!!
Do NOT allow children to play with the keypad!
system and have been instructed in its function.
Advertisement
