Before Using The Appliance - Ga.Ma Gcx623 Sport User Manual

BEFORE USING THE APPLIANCE:

Before charging the appliance for the first time we recommend fully discharging the battery and then fully
charging it.
1. Make sure that the appliance is switched off.
2. Plug the adapter into the USB port of your PC, Notebook or Tablet and then connect it to the device. A
standard USB adapter (5V 1000 mA) may be used. The charging LED will light up and remain red for the
whole charging process. The accessory holding charging base can also be used to charge it. In this case
insert the adapter plug directly under the base. The special compartment for inserting the cord has a cover
that must be opened to allow inserting the cord; once the cord has been inserted, the cover must be put back
in place so the cord does not move. There is an undercut for the cord on the extreme rear of the base to keep
it from being squashed by the base and risk being damaged.
3. The first charge takes 12 hours. Subsequent charges take about 8 hours. When fully charged, the battery
will last about 45 minutes.
4. Once it is fully charged, disconnect the adapter from the USB port of your PC, Notebook or Tablet or from
the power outlet.
5. Thanks to its cord-cordless function the appliance may be used connected directly to the USB port or
power outlet if the battery charge is depleted.
The duration of the battery varies based on usage frequency and times. To increase the lifespan of the
batteries, this procedure should be carried out at least twice a year, discharging the battery completely and
recharging it for the maximum time. If the appliance is not used often, remember in any case to carry out a
charging cycle every so often during the year to keep it working efficiently. On the contrary, when the charging
is finished, do not keep the appliance connected to the mains to prevent the battery from overcharging and
damaging the appliance.
WARNING: Do not attempt to replace the internal battery of the hair clipper. This can lead to the risk of
fire or electric shock. Tampering invalidates the warranty on the product.
INSERTION OF THE INTERCHANGEABLE HEADS:
The insertion method is identical for all heads.
19
There is a shaped
snap seat on the inside
of the upper part of the
appliance. Fig.1
To insert the heads, grasp the multifunction appliance by the rear side. With the other hand, take the head to
be inserted and line up the black lever of the head with the snap seat found inside the product. When the lever
has been inserted into the snap seat, push towards the front part of the appliance until you hear a slight click:
insertion will now be completed.
REMOVAL OF THE INTERCHANGEABLE HEADS:
The removal method is identical for all heads.
To remove the heads, grasp the multifunction appliance by the front side, place your thumb over the head and
push outward until the head is completely removed.
INSERTION AND REMOVAL OF COMBS:
To insert the attachment combs on the hair clipper head, slide the blade against the inner wall of the comb up
to its teeth and then push the base of the comb against the base of the blade head until you hear a slight click:
insertion will now be completed. Remove the combs using the tab located on the base of the comb, exerting
an outward force.
To insert the attachment comb on the beard trimmer head, slide the blade against the inner wall of the comb
up to its teeth, in this case also until you hear a slight click: insertion will be now be completed. To remove the
comb push upward on its base until it is completely removed.
There is a kind of black
lever on each individual
head. Fig.2
20