Installing The Antenna; Installing The Belt Clip; Installing The Optional Speaker/Microphone; Getting Acquainted - Adesso TP-3200 Instruction Manual

Installing the Antenna

Hold the antenna base and screw the anten-
na clockwise into the antenna connector at
the top of the transceiver, until tighten.
NOTE: Don't hang keys, speaker or micro-
phone on the antenna. Otherwise the
antenna will be damaged or perfor-
mance of the radio will be degraded.

Installing the Belt Clip

If necessary, can use two 3 x 8mm screws in
the package to fix the belt clip.
NOTE:
‹ If not install the belt clip, its installation lo-
cation will get hot in the hot environment
or in the continuous communication.
‹ You must remove the belt clip before re-
moving the battery pack.
Installing the Optional Speaker/
Microphone
Outward apart the moisture-proof rubber of
the headphone mouth, Insert the speaker/
microphone plugs into the speaker/micro-
phone jacks.
NOTE: The transceiver is not fully waterproof
while using the speaker/microphone.
5

GETTING ACQUAINTED

Antenna
LED indicator
Lights red while
transmitting.
Lights green while
receiving a signal.
Purple light flashing
when transmit with
low battery power.
Speaker
Microphone
Channel
PTT (Push-To-
Talk) Switch
Press, then
speak into the
microphone to
call. Release to
receive.
Monitor key
Press and hold to
turn the squelch
OFF. You will
hear background
noise. Release to
turn the squelch
ON.
Channel selector
Rotate to select
channels 1~199.
Power switch/
Volume control
Turn clockwise
to switch ON the
transceiver. To
switch OFF the
transceiver, turn
counterclockwise
until a click sounds.
Rotate to adjust the
volume level.
Speaker/
Microphone
jacks
Battery pack
6