Cleaning; Warranty - Univex DR11 Operator's Manual

4. As the Lifting Lever is pulled towards you, press the Start Button to engage the Rounding
late.
5. Once the Lifting Lever is pulled to the end of its stroke, a handle lock will engage to hold the
Lower Rounding plate in place while it completes the rounding cycle. To release the lock,
hold the Lifting Lever with the right hand and reach to the left side of the machine. The lock
lever is located at the midpoint of the machine. With weight applied to the Lifting Lever,
release the lock lever and slowly release the Lifting Lever.
6. Once complete, remove the dough tray and insert a new, clean tray into the DR11/14.
Remove the divider pan and replace with a new, filled dough pan.
7. Remove the divided portions from the pan and set them on another dough tray so it is ready
to go through the rounding process. Fill the empty pan with the appropriate weighted dough
and ready it for the next dividing action.

CLEANING

Use a mild detergent and warm water to clean the divider pan, dough tray and outside of the mixer. When
cleaning the Rounder Cups, use mild detergent and coat with light oil. This will help prevent the dough from
sticking to the inside during the rounding process. Do not use direct spray or hose to wash this
machine! The machine is not rated for direct spray and water may get into the unit and cause damage. Any
damage as the result of water entering the unit due to direct spray or immersion of the machine will void all
warranties.
The Univex DR11 and DR14 Divider Rounders carry a one-year, on-site parts and labor
warranty against any defects in materials or workmanship. The one-year period begins on
the date of purchase by the end user and remains in full effect provided the unit is used
properly in accordance with our instructions. Any work to be performed under this warranty
must be performed between the hours of 8:00 AM and 5:00 PM local time, Monday
through Friday. Univex will not cover overtime charges of any kind. Please contact the
Univex Warranty Service Department at 1-800-258-6358 to report warranty claims before
arranging repair or attempting to return the unit to Univex Corporation.
Damages incurred in transit or incurred because of installation error, accident, alteration or
misuse are not covered. Transit damage should be reported to the carrier immediately.
Univex will not be liable for any consequential, compensatory, incidental or special
damages.
Lock Lever

WARRANTY

9 of 9