Page 1
Switch SWITCH Introduction (https://www.youtube.com/watch?v=thJhTgRD2mE) The Switch is our first induction heating unit capable of vaporizing oil or leaf materials with precise power and carefully calibrated temperature profiles. Induction heating is significantly faster than any other heating method currently available and designed to create an even heating surface temperature with less hot-spots, providing a consistent flavor during the vaporizing experience.
Page 2
Over-voltage, over-current, under-voltage, over-temperature, short-circuit, and reverse-polarity protection built into the unit How to use your Switch User Guide (https://www.youtube.com/watch?v=GXzhWHiy0rI&t=31s) 1. Fill glass attachment with water and place on Switch unit. 2. Load induction cup and place inside heating chamber with included tweezers. https://drdabber.helpscoutdocs.com/article/98-switch-knowledge-base...
Page 3
To access crystal mode, the Switch must be powered down from advanced mode. To enter crystal mode, press and hold the (+) button and power on the device by flipping the power switch to either Leaf or Oil. The front LEDs will illuminate White indicating crystal mode. ...
Page 4
Flower Use and Tips When using the Switch with flower, we recommend starting low temp (around 400) and working your way up to find the best temp for you personal needs. We recommend setting the temp at 420 for a more traditional vaping experience.
Page 5
*Cleaning cycle will not activate in Crystal Mode.* Make sure to keep your Switch unit and induction cups clean. Remove the glass attachment and induction cup from the unit. Using a cotton swab or paper towel dipped in isopropyl alcohol, we recommend 91% or higher isopropyl alcohol for best results, clean any residue in and around the induction chamber.
Page 6
The Smooth Ceramic Cup is used for vaporizing oils, but can also be used for low heat flower vaporization. Please note, for optimal results, the Switch must be in crystal mode to use the Smooth Ceramic insert.
NOT void your warranty. The battery is located under the bottom base plate. To remove the base plate, hold the switch unit upright and slightly twist this plate until it falls away from the unit. The base plate is held in place with magnets, so you just need to twist it enough to disengage the magnets.
Page 8
4/9/22, 4:49 PM Switch Knowledge Base - Dr. Dabber Knowledge Base Find Us! Feel free to check out our instruction videos by visiting our Dr. Dabber YouTube Channel (https://www.youtube.com/channel/UC0NVkIgwKy-ttYw9RSumj6w/videos) or follow us on Instagram (https://www.instagram.com/drdabber/), Twitter (https://twitter.com/DrDabber), Discord (https://discord.gg/FruQXQh6), and Facebook (https://www.facebook.com/drdabber/). ...
Need help?
Do you have a question about the Switch and is the answer not in the manual?
Questions and answers