Table of Contents
Advertisement
AIR SUPPLY SETUP
IMPORTANT: Apply thread sealant tape to all male threads in your air line for airtight
connection .
3. Close the in-line shutoff valve between the compressor and the tool.
4 . Turn on the air compressor according to the manufacturer's directions and allow it
to build up pressure until it cycles off.
5 . Adjust the air compressor's output regulator so that the air output is enough to
properly power the tool, but the output will not exceed the tool's maximum air
pressure at any time . Adjust the pressure gradually, while checking the air output
gauge to set the right pressure range .
IMPORTANT: An individual air tool has its specification of air consumption (CFM).
Check the specifications of your air compressor to be sure that it can support both
minimum CFM (cubic feet per minute) and PSI (pounds per square inch) required .
An air hose (like 3/8" x 50 ft . air hose) may cause up to 15 PSI drop in pressure
from the air compressor to the tool, so you may need to set the output air pressure
of the compressor higher to maintain the required pressure at the tool .
TOOL SETUP
1. Remove the hopper lid (1) and fill the hopper (2) with the provided
abrasive sand (3) in bottle . Ensure that you are not exceeding the
maximum fill level for the hopper of 17.2 oz. (Fig. 1)
IMPORTANT: Use the provided abrasive sand or other blasting medium which
does not contain silica . Heed the safety instructions provided by the manufac-
turer of the blasting medium .
IMPORTANT: Ensure that the blasting medium is totally dry and not too coarse-
grained . Moist or too coarsegrained blasting medium will clog the gun .
2. Replace the hopper lid once the hopper is filled.
3
FIG. 1
4
6
7
1
2
5
4
Advertisement
Table of Contents
