Activation Of Programmed Outputs; Shortcut Key; Timer Menu; Residual Credit Display - AMC X Series User Manual

ACTIVATION OF PROGRAMMED OUTPUTS

In this menu it is possible to ACTIVATE / DEACTIVATE previously duly
programmed OUTPUTS. Enter the menu, position on the desired output (right/
left arrows) and use the UP/DOWN arrows to activate/deactivate.
The figure displays what is shown in the Menu. The outputs that can be
managed are only those with 0 = deactivated and 1 = activated.
The outputs with "dash" cannot be activated because they are programmed
with other functions.
Once in the activation menu, use the horizontal arrow keys to switch from
one output to the other and the vertical arrows to activate or deactivate
(UP arrow = activate, DOWN arrow = deactivate)

SHORTCUT KEY

The system is equipped with shortcut keys with which to perform activations
be set by the installer).
SILENT PANIC: activated by pressing simultaneously for 2 seconds the keys G2 and G3
PANIC WITH SIREN: activated by pressing simultaneously for 2 seconds the keys G1 and G4
If there are no particular programmings, the system siren is activated.
COMMANDS ACTIVATION: holding down the corresponding number key for 2 seconds will activate the
desired command and the operation will appear on the keypad display (by commands it is meant for example
turning on lights, turning on heating etc.)

TIMER MENU

The control panel is equipped with a timer system, to arm/disarm the system automatically, to enable/disable
outputs, to enable/disable users (time slots).
Before the system is armed automatically, the user has one minute to stop the operation by entering his code.
During this minute the keypad will emit a warning beep.
In autoarming mode, the control panel will only activate if:
• all the detectors are ready
• no anomaly
The user can stop all timed operations as follows:
• enter the user menu
• go to the TIMER menu
• press enter to modify the parameter: (0 = timers disabled, 1 = timers enabled)

RESIDUAL CREDIT DISPLAY

In the event memory it is possible to view the insufficient residual credit (default = 3€) of the SIM if it is inserted
in the control panel. In the CREDIT MANAGEMENT menu it is possible to change the default threshold.
If there is an operator not included in the preconfigured list, it is possible to add it to the list by accessing
the "TEL. provider" and "SMS provider" menu and entering the data relating to the specific mobile telephone
operator.
N.B.: not all mobile operators support this service
www.amcelettronica.com
GARDEN LIGHT
ACTIVATED
(in the programming phase they must
GARDEN LIGHT
DEACTIVATED
7
ACTIVATE
OUTPUTS
[05] OUTPUT 05
0 - - - 0 - - - - - - - - - - - - -
[05] OUTPUT 05
0 - - - 1 - - - - - - - - - - - - -
System management from display keypad