OSP Designs POLARIS PLR828-ES Assembly Instructions Manual

Laptop cart

Table of Contents

Download this manual

OSP Designs Warrants, to the original purchaser its products to be free from defects in material and workmanship for a period of 90 days. Defects

and damage from misuse, abuse, negligence, alteration, accident, vandalism, rusting, acts of nature or any other event beyond the control of OSP

Designs is not covered. The warranty does not cover cosmetic damage that may result from normal use. Liability for incidental or consequential

damages is excluded. The user assumes all risk of injury resulting from use of this product. This warranty gives you speciﬁc legal rights, and you

may also have other rights which vary from state to state.

To make a warranty claim, contact Customer Service, provide model number, sales receipt and description of the problem. It is the customer's

responsibility to prepay freight on any components returned to the factory. OSP Designs will pay return freight on components covered under

terms of warranty.

Our quality standards are among the highest in the industry. Sometimes, no matter how hard we try, there are times when hardware is missing.

Our Parts Department will do everything possible to promptly remedy the problem. Contact us via email parts@ofﬁcestar.net, by Fax

1-909-930-5629, or toll free parts number 1-800-950-7262, Monday through Friday 8:00 a.m. - 5:00 p.m. Paciﬁc Time. OSP Designs P.O. Box

3520 Ontario, California 91761 USA

PLR828-ES

POLARIS LAPTOP CART

ASSEMBLY INSTRUCTIONS

WARNING

1. Do not use this product unless all screws and bolts are securely

tightened.

2. Check that all screws and bolts are tight every three months or as

needed.

3. Dispose of packing material properly. Do not use plastic cover as

head covering. It may cause suffocation.

4. Do not use this product as a stepladder.

5. Use this product for its intended purpose only.

6. Intended for residential use only

Table of Contents

Do you have a question about the POLARIS PLR828-ES and is the answer not in the manual?

Page 1 LIMITED WARRANTY OSP Designs Warrants, to the original purchaser its products to be free from defects in material and workmanship for a period of 90 days. Defects and damage from misuse, abuse, negligence, alteration, accident, vandalism, rusting, acts of nature or any other event beyond the control of OSP Designs is not covered.
Page 3 Neck Clamp...
Page 5 STEP 1 Insert both Locking Casters (E) to front of Base (5) and both Casters (F) to rear of Base (5). Push hard until you feel or hear caster snap into place. STEP 2 Secure Post (3) to Base (5) using two Flat Washers (B), two Lock Washers (C) and two Bolts (A). FULLY TIGHTEN ALL BOLTS (A) USING WRENCH (D).
Page 6 STEP 3 Slide Neck (2) down into Post (3). STEP 4 Secure Clamp (4) to rear Post (3) using Rubber Washer (H) and Knob (G). FULLY TIGHTEN KNOB (G).
Page 7 STEP 5 Slide panels of Table Top (1) outwards. Attach Table Top (1) to Neck (2). STEP 6 Slide panels of Table Top (1) to secure Table Top (1) to assembly.
Page 8 HEIGHT ADJUSTMENT To adjust table top, loosen Knob (G), raise or lower table top, tighten Knob (G) once desired height is reached. NOTE: BE CAREFUL NOT TO LOOSEN KNOB (G) COMPLETELY. ATTENTION: MAKE SURE BOLTS & KNOBS ARE ESECURELY TIGHTENED BEFORE USING THIS PRODUCT.