Related Manuals for Boss Snowplow MSC23000
Summary of Contents for Boss Snowplow MSC23000
- Page 1 Form No. MSC23001 Rev A Owner's Manual Straight Blade Plow for Dingo Compact Tool Carriers Part No. MSC23000—Serial No. 400000000 and Up *MSC23001* A Register at www.bossplow.com. Original Instructions (EN)
-
Page 2: Table Of Contents
This product complies with all relevant European Date directives; for details, please see the separate product Purchased specific Declaration of Conformity (DOC) sheet. Model No. BOSS Products limited consumer warranty and BOSS Products commercial warranty policies are located at Serial No. www.bossplow.com. -
Page 3: Safety
Safety • Turn the vehicle and plow off before filling, servicing, or cleaning it. • Do not climb into or ride on the plow. Improper use or maintenance by the operator or owner can result in injury. To reduce the potential •... -
Page 4: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decalmsc23037 MSC23037 1. Warning—read the Owner’s Manual. 5. Warning—shut off the engine, remove the key, and read the Owner’s Manual before performing maintenance. -
Page 5: Setup
Setup Note: Determine the left and right sides of the machine from the normal operating position. Installing the Push Frame Loosely secure the 2 mounting brackets to the plow using 2 bolts (5/8 inch) and nuts (Figure g297804 Figure 4 1. -
Page 6: Installing The Hydraulic Hoses
using 2 washers (1/2 inch) and nylon locknuts (Figure Tighten the nylon locknuts until there is a gap of 0.8 mm (1/32 inch) between the trip spring coils. Installing the Hydraulic Hoses Remove the crossover cover (Figure g297807 Figure 7 1. -
Page 7: Mounting The Plow
Product Overview g297808 Figure 8 2. Long hoses 1. Quick couplers Attach the quick couplers to the free end of the long hoses, as shown in Figure Install the previously removed crossover cover. g297809 Figure 9 Mounting the Plow 1. Trip springs 3. -
Page 8: Operation
Operation Mounting and Removing the Plow Refer to your Dingo compact tool carrier Operator’s Manual for instructions on mounting and removing attachments. Operating the Plow Refer to your Dingo compact tool carrier Operator’s Manual for instructions on operating attachments. Operating Tips •... -
Page 9: Maintenance
Maintenance WARNING Failure to properly maintain the machine could result in premature failure of machine systems causing possible harm to you or bystanders. Keep the machine well maintained and in good working order as indicated in these instructions. CAUTION If you leave the key in the switch, someone could accidently start the engine and seriously injure you or other bystanders. -
Page 10: Storage
Storage Storing the Plow Drive the plow to your storage location and remove the plow; refer to your Dingo compact tool carrier Operator’s Manual. Grease any exposed metal on the hydraulic cylinder rods. Lightly sand and use touch-up paint on painted areas that are scratched, chipped, or rusted. -
Page 11: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action Oil leaks from the hydraulic cylinders. 1. The hose is bad. 1. Check the hose for leaks. Apply thread locking compound to the connection or replace the hose. 2. The cylinder is bad. 2. Replace the cylinder. 3.
Need help?
Do you have a question about the MSC23000 and is the answer not in the manual?
Questions and answers