Table of Contents
Related Manuals for Chloride ONEAC
Summary of Contents for Chloride ONEAC
- Page 1 A H I G H E R L E V E L O F C O N F I D E N C E Replacement Battery Installation For Use with ON Series ® Conditioned UPSs User Installation Instructions Standard Rackmount Wallmount Universal Mount A Chloride Power Protection Company...
-
Page 3: Important Safety Instructions
Toll Free: (800) 327-8801 Facsimile: +44 (0) 2380 610852 Facsimile: (847) 680-5124 Entire contents copyright © 2005 ONEAC Corporation. All rights reserved. Reproduction in whole or in part without permission is prohibited. All information subject to change without notice. 913-338 Rev. E... -
Page 5: Technical Support
ONEAC battery packs can be replaced without turning off the power or disrupting the protected equipment. This document provides instructions for replacing battery packs in the ONEAC ON Series UPS products. After replacing the batteries in the ON Series UPS products, the LED display should give the % load the UPS is supporting. - Page 6 (ON400 shown below.) See “Returning Depleted Batteries” on page 9. for instruction on returning depleted battery pack(s) to ONEAC. Fig. 1: Battery Replacement for Standard UPS ON Series Replacement Battery Installation...
-
Page 7: Rack-Mounts
Once the battery pack is in place, insert the plug and attach the wire retainer and front cover. See “Returning Depleted Batteries” on page 9. for instruction on returning depleted battery pack(s) to ONEAC. Fig. 2: Battery Replacement for Rack-mount UPS ON Series Replacement Battery Installation... -
Page 8: Wall Mount
Attach the front cover. See “Returning Depleted Batteries” on page 9. for instruction on returning depleted battery pack(s) to ONEAC. Fig. 3: Battery Replacement for Wall-mount UPS ON Series Replacement Battery Installation... -
Page 9: Universal Mount
Universal Mount Universal Mount Determine if your unit has a plastic or metal front bezel and follow the appropriate instructions below. Plastic Front Bezel Universal Mount ON700, ON1000 and ON1500 To replace the battery pack in the universal mount unit with a plastic front bezel: 1. - Page 10 Universal Mount 3. Disconnect the battery from the UPS by grasping and pulling the battery connectors straight out. 4. Slide battery out (fig. 6). Battery Fig. 6: Removing the Battery 5. Slide new battery into the UPS and reconnect the battery connector (fig.7).
- Page 11 See “Returning Depleted Batteries” on page 9. for instruction on returning depleted battery pack(s) to ONEAC. Metal Front Bezel ON700 and ON1000 To replace the battery pack in the universal mount unit with a metal front bezel: 1.
- Page 12 Universal Mount 3. Once the bezel is removed, remove the four retaining screws from the battery retention plate located on the left (bottom) side of the unit (fig. 9). Battery Retention Plate Battery Connectors Front Bezel Fig. 9: Replacing Battery Pack 4.
- Page 13 Batteries battery purchases. Just follow these simple steps: 1. Remove the new battery pack and install it in the ONEAC unit as per the installation instructions. Put the UPS A.R.S label aside. 2. After the battery pack has been replaced, place the depleted battery...
- Page 14 Organizations whose productivity goals allow no possibility for system downtime use ONEAC. They include many of the world's leading companies, in a wide range of applications including telecommunication systems, information technology, retail information systems, computer-integrated manufacturing systems, semiconductor test equipment and biomedical instrumentation and information systems.
Need help?
Do you have a question about the ONEAC and is the answer not in the manual?
Questions and answers