Table of Contents
Advertisement
PT-56LCX70 / PT-61LCX70 / PT-50LCX7 / PT-56LCX7 / PT-61LCX7
SET UP for VCOM Adjustment:
1. 1) Remove the Rear Cover Unit.
2) Disconnect Connector CN6005 on the Main P.C.B.
3) Connect Connector CN6005 and PC (1) with the 8 Pin Extension Cable, the 7 Pin Extension Cable, the Relay PCB, the
RS232C I/F Tool, the D-Sub 9 Pin Serial (RS232C) Cable.
2. Install the software for VCOM adjustment into the PC (1).
Note:
The PC (1) must have a 10-key keyboard.
1) Copy the "2007_720P (33 files)" folder to C: Drive.
2) Execute the "Vcom2007_720P.exe" file.
3. Turn on the unit power.
CN6005
8 Pin Extension Cable
(LSUA0068)
Relay PCB
(LSUA0069)
7 Pin Extension Cable
(LSUA0064)
Connector Cable
from Lamp
LAMP
MAIN
SIDE
SIDE
RS232C I/F Tool
(LSUA0043)
PC (1) for VCOM Adjustment
D-Sub 9 Pin Serial
(RS232C) Cable
4. To turn the remote on, press DEL key.
"Manu" indication will change to "Auto" indication, and
"Remote ON" indication will appear.
Note:
Confirm NUMLOCK is on. If not, turn on NUMLOCK by
pressing the NUMLOCK key on the 10-key keyboard.
5. Perform the VCOM Adjustment.
6. After completing adjustments, turn the remote off by
pressing DEL key. Then, end the software.
48
Advertisement
Table of Contents
