Table of Contents
Advertisement
PT-56LCX70 / PT-61LCX70 / PT-50LCX7 / PT-56LCX7 / PT-61LCX7
6. Remove the Integrator Block Ass'y by removing the 4 screws.
7. 1) Remove the three Integrator 1 Springs by removing the 3 screws.
2) Remove the Integrator 1 from the Integrator Holder Unit.
8. 1) Remove the two PS Springs by removing the 2 screws.
2) Remove the P/S Converter by releasing the tabs of PS Holder.
3) Remove the AL Mask.
4) Remove the Integrator 2 by releasing the tabs of PS Holder.
Note:
Clean the optical components if necessary. Refer to "Cleaning Methods" in Maintenance.
421
Boss
421
Integrator Block Ass'y
PS Spring
408
View B
Integrator Holder Unit
Flat side
PS Holder
AL Mask
Flat side
P/S Converter
408
PS Spring
421
Reassembly Note 1:
Boss
The Integrator 1 Spring on this
side should face in the opposite
421
direction to the other two
Integrator1 Springs.
Integrator 1 Spring
Flat side
(B2)
Integrator 2
(MP076LA1)
Fig. P4-2
44
View A
407
407
Integrator 1
(B1)
Spring
Integrator 1 Spring
Integrator 1
(MP076LA1)
407
Advertisement
Table of Contents
