General Information; Reading And Keeping The Instructions For Use; Use For The Intended Purpose; Explanation Of Symbols - Workzone 937 User Manual

General information

General information

Reading and keeping the instructions for use

These instructions for use belong together with the rechargeable
LED work light (referred to below as "the work light"). They contain
important information about handling and setting up the product.
Carefully read through the instructions for use and especially the safety
instructions before using the work light. Failure to observe these instructions for use
could result in serious personal injury or damage to the work light.
These instructions for use are based on the standards and regulations applicable in
the European Union. For use abroad, please also observe country-specific standards
and local laws.
Keep these instructions safe for future reference. If you pass on the work light to
someone else, please make sure that you also give them the instructions for use.

Use for the intended purpose

This work light is designed exclusively for illuminating indoor and outdoor working
areas. It is intended solely for personal use and is not suitable for trade use.
You should only use the work light as described in these instructions for use.
The working light is designed for handheld use only. Any other use is considered
improper and may lead to material or personal damage. The work light is not a toy.
The manufacturer or dealer does not accept any liability for damages that occur
due to use other than according to the intended purpose or to improper use.

Explanation of symbols

The following symbols are used in these instructions, on the product itself or on the
packaging.
This symbol indicates useful additional information about operation.
Declaration of conformity (see chapter "Declaration of conformity"):
Products marked with this symbol comply with all applicable European
Economic Area regulations.
6
This symbol indicates electrical equipment that complies with
protection class III. That means that the work light runs on low-
voltage electricity and is operated by a safety extra-low voltage
(SELV).
This symbol indicates that a device operates under direct current.
USB connection

Safety

Explanation of notices

The following symbols and signal words are used in these instructions for use.
This signal symbol / word indicates a moderate
WARNING! degree of risk. If this risk is not avoided, it may
lead to death or severe injuries.
This signal symbol / word indicates a low degree
ATTENTION! of risk. If this risk is not avoided, it may lead to minor
or moderate injuries.
This signal word indicates possible material
PLEASE NOTE!
damage.
Safety
7