Advertisement
Note 2:
When "ANG" is displayed, follow the item of "operation check" in "Troubleshooting Guide" and
check for a malfunction.
*To exit the adjustment mode, remove the battery.
Checking the main unit's keys
1. Check the PC board. (Refer to the item of "Check for the P.C.B."
in "Operation Checks and Main Component Replacement
Procedures").
2. Set the battery and connect the remote controller.
3. Turn off the power. Then, with the main unit's HOLD switch at
OFF, press the VOL+, VOL-,
remote controller within two seconds without pressing the OFF
button.
A. Using your thumb, while pressing the VOL+ button, also press
the VOL- button.
B. Then, while still pressing the VOL- button, release your thumb
from the VOL+ and press the
C. While still pressing the
the VOL- button and press the
pressing the
button and then from the
)
, and
button, release your thumb from
button, release your thumb from the
button. (a-c are shown in
Fig.5
13
buttons on the
button.
button. Then, while still
Fig.5
Advertisement
