Recognizing Existing Controls - MAKESafe Tools PTB-V120-P1 User Manual

Recognizing Existing Controls

The MAKESafe Power Tool Brake is designed for plug-and-play use on tools with a simple on/off
switch and no pre-existing electronic controls. If your power tool has any other controls, electronic
indicators, digital displays, electronic dials or variable controls, magnetic switches, or variable
frequency drives - additional wiring and consideration may be required. Contact MAKESafe Tools
for assistance and we'll help you to determine the best way to proceed with the installation.
Tip:Some existing controls can be safely bypassed (as the function also exists in the Power
Tool Brake) but this should be confirmed by an expert on a case-by-case basis. Please call
MAKESafe Tools for assistance.
Warning: Below are some examples of existing controls that would prevent a plug-and-play
installation. If your machine has any of the following controls, please contact MAKESafe Tools
before proceeding with your installation:
Note: this is a list of examples but does not represent every possible control. If in doubt, contact
MAKESafe Tools.
Variable Frequency Drive (VFD), Inverter, or Electronic Speed Control
MAKESafe Tools, Inc. | Copyright 2021 | Last Updated 12/29/21
Magnetic Switch
Starter
Note: Many of the switches
shown above could be a
magnetic switch or a simple
on/off switch as they look similar.
The following section provides a
simple procedure to determine if
your machine has a magnetic
switch installed.
Page 8