Maintenance - AEG AEDG10 Original Instructions Manual

ADDITIONAL SAFETY WARNINGS
a of
■ Some regions have regulations that restrict the use of the
for
product. Check with your local authority for advice.
erty.
■ Avoid using the product in bad weather especially if there is a
wear
risk of lightning.
ind.
■ Avoid using the product on wet grass.
and
■ Hearing protection may restrict the operator's ability to hear
warning sounds. Pay particular attention to potential hazards
the
around and inside the working area.
ch if
ADDITIONAL BATTERY SAFETY WARNINGS
that
■ To reduce the risk of fire, personal injury, and product damage
n or
due to a short circuit, never immerse the tool, battery pack, or
s to
charger in fluid or allow fluid to flow inside them. Corrosive or
conductive fluids, such as seawater, certain industrial chemicals,
and
and bleach or bleach-containing products, etc., can cause a
short circuit.
■ Charge the battery pack in a location where the ambient
oper
temperature is between 10°C and 38°C.
■ Store the battery pack in a location where the ambient
dger
temperature is between 0°C and 40°C.
■ Use the battery pack in a location where the ambient
aces
temperature is between 0°C and 40°C.
and
TRANSPORTATION AND STORAGE
ctly
■ Turn off the product, remove the battery pack, and allow both
to cool down before storing or transporting.
with
■ Remove all foreign materials from the product.
t of
■ Check all nuts, bolts, and screws before each use and at frequent
intervals for proper tightness to ensure that the product is in
ront
safe working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service centre.
■ Do not store or transport the product with the battery pack
ving installed. Remove the battery pack, and secure it separately.
Store the product in a cool, dry, and well-ventilated place that is
and
inaccessible to children. Keep the product away from corrosive
ave
agents, such as garden chemicals and de-icing salts. Do not
store the product outdoors.
■ For transportation in vehicles, secure the product against
movement or falling to prevent injury to persons or damage to
the product.
TRANSPORTING LITHIUM BATTERIES
fore
■ Transport the battery pack in accordance with local and
national provisions and regulations.
■ Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that no
batteries can come in contact with other batteries or conductive
materials while in transport by protecting exposed connectors
with insulating, non-conductive caps or tape. Do not transport
of a
batteries that are cracked or leaking. Check with the forwarding
that
company for further advice.
and

MAINTENANCE

■ Use only original manufacturer's replacement parts, accessories,
ture
and attachments. Failure to do so can cause possible injury, can
contribute to poor performance, and may void your warranty.
■ Servicing requires extreme care and knowledge and should
be performed only by a qualified service technician. Have the
product serviced by an authorised service centre only. When
servicing, use only original replacement parts.
■ Turn off the product and remove the battery pack before
conducting any maintenance or cleaning work.
■ You may make adjustments and repairs described in this
manual. For other repairs, contact an authorised service centre.
■ After each use, clean the product with a soft, dry cloth. Any part
that is damaged should be properly repaired or replaced by an
authorised service centre.
■ Check all nuts, bolts, and screws before each use and at frequent
intervals for proper tightness to ensure that the product is in
safe working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service centre.
■ Bring the product to an authorised service centre to replace
damaged or unreadable labels.
SYMBOLS
Read and understand all instructions before
operating the product. Follow all warnings and
safety instructions.
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Wear eye and ear protection.
Direction of edger blade rotation
Keep feet away from rotating blade.
Do not expose the product to rain or damp
conditions.
Beware of thrown or flying objects. Keep all
bystanders, especially children and pets, at least 15
m away from the operating area.
Keep hands away from the cut-off blade.
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authority or
retailer for recycling advice.
Guaranteed sound power level
19
19