Table of Contents
Advertisement
- Removing the LO Arm Assy
1. Remove two Pins to dismount the LO Arm Assy.
- Removing the Control Unit and the Spindle
Motor
1. Remove from the connector after mounting the Short
pin on the flexible PCB of the pickup unit.
2. Remove two soldered joints, then remove two screws
A.
3. Remove two connectors and a Screw B.
4. Disengage the Control Unit from two Tabs, then
dismount the unit by sliding it toward left.
5. Dismount the Spindle Motor.
- Removing the Loading Motor and Carriage
Motor
1. Remove the spring and two screws A.
2. Dismount the Loading Motor.
3. Remove the Belt, a screw B, two screws C, a Guide and
a Screw Unit.
4. Dismount the Carriage Motor.
Note : When assembling the Belt, use care so that it may
not be contaminated by grease.
LO Arm Assy Section
Short Pin
Spindle Motor
B
Control Unit
Screw Unit
A
FH-P8800
A
A
C
Guide
B
Carriage Motor
Belt
C
A
Loading Motor
87
Advertisement
Table of Contents
