Pioneer FH-P8800 Service Manual page 84

FH-P8800
- Removing the upper block of the CD mech
module
1. Remove the 4 screws and the connector. Then take
out the CD Mechnism Module. (Not shown in the
figure).
2. Remove the 7 screws and the Heat Sink.
3. Remove the 7 screws and the connector. Lift the CD
section together with the Cassette Mechanism
Heat Sink
Cassette Mechanism
Audio Amp Unit
- Removing the CD power unit
1. Remove the 3 screws.
2. Straighten the 4 hooks marked with an arrow.
Remove the CD Power Unit.
When connecting the Deck Unit (Cassette Mechanism
Module) to the Audio Amp Unit, push the Deck Unit
84
CD Section
CD Power Unit
Deck Unit
(Cassette Mechanism Module)
Module upwards, and remove it.
CD Power Unit
through the hole by hand to insert the connector.