Makita DVP180 Instruction Manual page 7

Fig.2:
1. e in icator
2. Button
o remo e the battery cartri ge, sli e it rom the pump
while sli ing the button on the ront o the cartri ge.
o install the battery cartri ge, align the tongue on the
battery cartri ge with the groo e in the housing an slip
it into place. nsert it all the way until it locks in place with
a little click. you can see the re in icator on the upper
si e o the button, it is not locke completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen.
may acci entally all out o the pump, causing injury to
you or someone aroun you.
CAUTION:
Do not install the battery cartridge
forcibly. the cartri ge oes not sli e in easily, it is not
being inserte correctly.
Battery protection system
Fig.3:
1. Star marking
he pump is e uippe with a battery protection system.
his system automatically cuts o power to the motor to
e ten battery li e.
he pump will automatically stop uring operation i the
pump an or battery are place un er one o the ollowing
con itions
Overloaded:
he pump is operate in a manner that causes it to raw
an abnormally high current.
n this situation, turn the pump o an stop the application
that cause the pump to become o erloa e . hen turn
the pump on to restart.
the pump oes not start, the battery is o erheate .
n this situation, let the battery cool be ore turning the
pump on again.
Low battery voltage:
he remaining battery capacity is too low an the pump
will not operate. n this situation, remo e an recharge
the battery.
NOTE: he o erheat protection works only with a
battery cartri ge with a star marking.
Indicating the remaining battery
capacity
Only for battery cartridges with "B" at the end of the
model number
Fig.4:
1. n icator lamps
ress the check button on the battery cartri ge to in icate
the remaining battery capacity. he in icator lamps light
up or ew secon s.
3. Battery cartri ge
not, it
2. Check button
Indicator lamps
Lighted Off
NOTE: epen ing on the con itions o use an the
ambient temperature, the in ication may i er slightly
rom the actual capacity.
OPERATION
he pump oes not contain oil when newly purchase .
e er to A ing oil an a
WARNING:
condition without oil added will damage the pump.
n a ition, the oil tank will become hot an may result
in burns or other acci ents.
Adding oil
Fig.5:
1. il ll E haust cap
2. e el line
1. emo e the oil ll e haust cap an a
oil ia the ller port.
NOTICE:
Always use Makita genuine oil in or er to
maintain pump per ormance.
2. A oil until the oil le el is between the upper an
lower le el lines o the sight glass.
NOTICE:
he oil le el is important.
pump in the con ition with the oil le el not between the
upper an lower le el lines may result in mal unction.
Checking performance
Fig.6:
1. ntake
2. ow si e al e
1. Connect the low si e al e o the mani ol an the
intake port o the pump with a charging hose.
2. Close the low si e al e o the mani ol .
3. pen the intake shut-o
7 ENGLISH
Remaining
Blinking
75
50
25
0
Charge the
may ha e
mal unctione .
oil.
Operating the pump
3. Sight glass
4. il tank
perating the
3. Vacuum pump
4. Mani ol
al e.
capacity
to 100
to 75
to 50
to 25
battery.
he battery
in the
the supplie