Connecting Devices - D-Link DWM-321D Quick Installation Manual

Connecting Devices

After the DWM-321D/DWM-321 has been successfully installed,
the router can be connected to the end device via the following
method:
Over Ethernet
The Ethernet port can be connected to an end device. Use a
standard Category 5/5e/6 RJ-45 Ethernet cable to connect the
end device to the router. The port will auto-negotiate to the
highest possible port speed based on the connected device.
Note that the DWM-321D/DWM-321 supports a maximum transfer
speed of 1000 Mbps over Ethernet.
Over Wi-Fi
You can connect to the router using the SSID and security settings
listed on the bottom of the router. If your Wi-Fi has previously
been configured, use those settings instead. The router supports
up to 802.11n speeds on the 2.4 GHz network and up to 802.11ac
speeds on the 5GHz network. Maximum transfer speeds are
dependent on network conditions.
9
DWM-321D/DWM-321